Rutland 913 Marine Windcharger

      The Rutland 913 is designed for marine use on board coastal and ocean going yachts usually over 10m in length. This unit will generate enough power to serve both domestic and engine batteries on board and the RWS200 Controller is available for dual battery charging.

Low wind speed start up of just 5 knots 12V  system generates 3.5amps @15 knots, 6amps @ 20 knots. Delivers up to 300 Watts One-way-only-fit fine profile efficient aerofoil blades Automatic thermostat protection in prolonged gales Modern, durable materials for reliability on the high seas Weight : 10.5kg                    Turbine diameter : 910mm      No radiated interference - complies with EEC directive 89/336/EEC            12V Charger (Code CA01/15)       Price : £ 469.00          24V Charger (Code CA01/16)     Price : £ 469.00

Balance of System Components

• NEW : HRSi voltage controller (for the 913 & 910-3) and which now allows up to 160W of solar PV panels in a single, easy-to-install device. Note: solar panels must be fitted with diodes.
• Has PWM (pulse width modulation) to prevent battery overcharge. As peak voltages are reached the HRSi tapers the input charge from the wind and solar chargers, gradually reducing input to float stage level in the batteries. This feature gradually reduces the speed of the turbine to an eventual ''idle'' thus extending the working life of the windcharger. As the battery discharges the wind turbine responds by increasing speed to deliver more power. Solar power is also tapered in the same way.
• LED indicators keep the user informed about battery charging levels and charging status.
• Manual shutdown switch allows the user to stop the wind and solar chargers from delivering power to the battery if required.
• Automatic voltage detection 12 or 24V. Note : batteries must be connected first for auto-detection.
• Built-in charge fuse protects the wiring circuit in the event of accidental reverse polarity connection.

                 HRSi controller.     Price = £69.00 inc VAT

• Marine Mounting Kit supplied in 2 sections of stainless steel plus deck fixing and fasteners.
• Other system components
  Batteries, cable

  HRDX regulator.

  Charge splitter for 2 battery banks.

  State 12 or 24V

    Price : £ 149.00      

Incorporates regulator and selectable LCD display.

Solar panel input up to 100W (Schottky diode required)
Prevent battery overcharge.
Fit between the Windcharger / solar and battery.
All models are diode protected to allow charging from other sources to the same battery.